HC300 Hand Held Hot Knife / Wire Foam Cutter with Heavy Duty Case

Supplied in a heavy duty carry case for protection and transporting.

Ideal solution for your Styrofoam cutting applications.

Handheld braid/hot knife Foam cutter is recommended for short-time operation and low volume.

Heat up time is approx 6-8 seconds. Heat may be controlled by switching on and off. It is suitable for cutting rope up to 18mm in diameter. The cutter gives a clean neat cut that also prevents rope/braid from fraying. Cut the rope with diameter 2cm, and webbing, with fine cutting edge. Specially good for cutting sail cloth, awnings and filter cloth.

Features & Benefits:

• 60 W 230-240V Operation

• Fitted with BS1363 3 pin mains plug (standard)

• Built-in guide lamp

• Hanging hook

• HCB300 cutting blade included

• Blades operating temperature = 750°C

• Operates continuously when the trigger is held down.

• Size of Blade: 32mm Wide x 5mm Deep

• Supplied in a heavy duty case.

This is perfect for all types of applications that need a hot knife cutter that will be used often but not all the time. It is of very good quality and will not let you down.

This melting not only cuts the sleeving to the desired length, but also fuses the loose ends of the filaments together to prevent fraying of the cut end during installation and use.

Applications:

Mount the blade to the posts and tighten. When the knife is turned on for the first time, there may be some smoking while the manufacturing oils burn off. Leave the knife on for about 20 minutes and turn it off. After it cools, check the tightening screws on the posts and retighten if necessary. Your knife is now ready to provide years of trouble free service. Check the tightening screws periodically to ensure good contact with the posts.